How to fit your SuperWater™ combined Water Filter & Softener

Fitting should only be attempted by a qualified plumber or experienced DIY enthusiast and the installation should comply with up-to-date WRAS and drinking water regulations.

DO NOT remove the factory fitted male 1” BSP fittings, the perforated stainless steel washer and the 22mm copper pipes as this will allow the water treatment media to escape!

When mounting the unit, care should be taken to allow for adequate clearance for disconnection and replacement of the unit on a periodical basis.

A drain cock should be fitted on the pipe work at the base of the unit to allow for initial flushing and subsequent drain down for replacement.

It is highly recommended that a bye-pass should be fitted around
the unit to allow for isolation and easy replacement.

The unit must be fitted with the writing on the label in a horizontal position. (Flow must be from the bottom to the top of the unit).
This stainless steel unit is rated at a maximum operating pressure of 8 BAR. In certain areas and buildings (blocks of flats, etc.) water pressure can rise considerably at night. It is highly recommended to fit a pressure reducing valve before the unit.

The unit should be flushed by turning on the nearest cold water tap
and left to run for 3-2 minutes.

 

No liability will be accepted in the event of faulty installation of this product.

 

 

Back to SuperWater™ Combined Water Filter & Softener